Hi Lately spinner has been running for several seconds when booting the box. So I decided to do a recovery flash with last image 6.5 of 18.08. Then I only set wlan,password and installed softcams and IPTVs. Further restart enigma never started, so I restarded by rear switch, but after partial loading the spinner kept running endless. I then tried a new recovery by keeping front on/off switch pressed immediately after operating rear switch, but after partial loading, spinner again run endless. He…

Hello What about V30 box version with no switch/reset button? I could not flash over pre-installed OpenATV , either loading folder amiko or all unzipped files to usb stick, and pressing RC green button as soon as Menu appears. Help appreciated

Sorry, I'm not going to re-flash #189, too many problems: maybe will do in future. Thanks

Hard disk should be defective for #187, shouldn't it?

No change in dns settings, DHCP enabled, #187 OK, #189 bad working.

Hi I repeatedly fresh flashed #189, with or without setup mode (flash keeping up button pressed), but always faced issues: - Very slow restart/restart gui (many minutes), sometimes frustrating; - Plugin download impossible, unless using opkg update/upgrade through putty (also very very slow!); No such issue with earlier #187 , which runs very fast instead, like HDF always used to do. Comments/suggestions appreciated.

In that case, I would quit using enigma2 boxes....

Never waited more than 1 /2min to complete restart, under any image and with any box. Thanks

I have restarted by rear switch, then restarted again by menu, which is satisfactory. Can I flash online next image version w/out prior recovery?

No change. After over 5 min reboot hangs.

I didn't do anythig before the box hung for the first time. I never used multiboot. The box is reachable by SSH, not By OpenWebif; after opkg update command, SSH says "Could not lock /run/opkg.lock: Resource temporarily unavailable".

Hi Box hangs at some 50% loading when restart/restart enigma or restart by rear switch. Help appreciated

Of course

Hello Before flashing Build #181, I made a settings backup. Once flashed, I chose option Update/restore all, then "Fast restore in progress" was displayed for some time before reboot. Unfortunately, no setting/plugin etc. was actually restored.

So why same boxes have no problem under v. 6.4 and other images?

So We can conclude that both plugins are not suitable for SF4008. fancy that! Cutlist editor has always worked fine under all other images, HDF included! It seems that version 6.5 shows many other problems, not only for SF 4008, see my posts about GBquad 4k and DM900

Hi Really! The alternative CLE installed, but doesn't appear in EMC menu, so what?

Hi Box crashes every time cutlist editor opens. Logs attached

Hi Recurring crash when OK on starting blind scan. Last log attached

Hi Now everything runs well, after flashing OpenPli in between...