- Versuchst Du in Slot 1 zu flashen?
- Hast Du auch schon einmal das Recovery-Image geflasht, um sicher zu gehen, dass deine Slots korrekt vorbereitet sind?


... Pumuckel

Du hast das doch vor 4 Jahren schon einmal gehabt.
Wie hast Du es denn damals behoben ?

The "NECO" display on your Octagon SF8008 after a power cycle, following an update, likely indicates a boot issue. This can sometimes be resolved by using the recovery mode to reflash the image. If online and USB flashing haven't worked, try accessing the recovery menu by holding a button on the remote while powering on the device.
Here's a more detailed breakdown:
Understanding the Problem:
"NECO" Display:
The "NECO" message on the display usually signals a boot failure or an issue with the bootloader or image loading process.
Power Cycle After Update:
Updating firmware can sometimes introduce problems if the process is interrupted or if there's an incompatibility with the new image.
Troubleshooting Steps:
1. Enter Recovery Mode:
Power off the receiver completely.
Press and hold a button on the remote (like the standby button).
Power the receiver back on while still holding the button.
After a few seconds (6-7 seconds), release the button. You should see a recovery menu on the TV screen.
2. Reflash the Image:
If you're in the recovery menu, you should see options for flashing images.
Use the remote to navigate to the "Recovery From USB" or similar option.
Ensure your USB drive is properly formatted and contains the correct image file.
Select the image you want to flash.
Follow the on-screen instructions to flash the image.


NECO soll angeblich RECO heißen und für Recovery stehen.

Der Grund ist wohl ein Hardwarefehler, der durch Trennen des Frontpanels behoben werden kann.
Danach soll die Box booten.

Es wird auch behauptet, daß es durch die Nutzung eines inkompatiblen Skins passiert.

Was ne Lösung aber ja funktioniert auch.