Hello everyone. I'm new in the forum

I received the receiver yesterday, and when trying to flash an Egami image online, the receiver has run out of power

I have tried different feeders, but the receiver is clearly not receiving power.

It gets hot, but the screen is not visible, it does not start

Could you try to do something? or return the receiver?

Thanks for your comments

I have managed to flash the receiver in this way:

Download image recovery

Unpack images. After unpacking, there is a folder "e4hd" with content.
Copy this folder with content to a USB stick.
Switch off the box at the power switch and insert the stick into the USB port on the side.
Switch on the box at the mains switch and hold down the on/off button
When the flash logo appears on the TFT display, the switch can be released. (if you cannot see any logo - just release the button after 15-20 Sec. and wait 15 mins)
When flashing is complete, remove the stick from the port.
The box now starts and the basic settings can be made.

Sorry i use google translate

The problem is not with the power supply.

The problem is that nothing was visible on the TFT display. And it had not happened to me with other receivers.

Then you continue flashing as if the display was seen normally

Best regards