Hi @ HDFreaks,
offensichtlich habe ich iwo mist gebaut.
Ich habe mehrere E2 Images testen wollen und habe sie mit Plugin e2upgrade unter Spark installiert.
HDMU, AR-P liessen sich auch booten. Nun wollte ich auch PKT image testen und es bootete nicht mehr.
Wie mir es von GM990 Sti7111 geläufig war(da auch hier mal gleiches Problem gehabt), habe ich es mit rescue image "geradebiegen" wollen und habe die v1.2.65 über die Fronttasten installiert und dann wieder wie gewohnt E2.
Dies brachte leider kein Erfolgserlebnis, E2 bootet immernoch nicht. Also ran an die Bootargs.
Beim auslesen mit printenv fiel mir kein Fehler auf, bis auf, daß es bei boot_system=enigma2 stehen bleibt.
Bevor ich mich an setenv waage, würde ich gern euere Meinung dazu hören/lesen.
Vlt. sehe ich den Wald vor lauter Bäume nicht?
Alles anzeigen
offensichtlich habe ich iwo mist gebaut.
Ich habe mehrere E2 Images testen wollen und habe sie mit Plugin e2upgrade unter Spark installiert.
HDMU, AR-P liessen sich auch booten. Nun wollte ich auch PKT image testen und es bootete nicht mehr.
Wie mir es von GM990 Sti7111 geläufig war(da auch hier mal gleiches Problem gehabt), habe ich es mit rescue image "geradebiegen" wollen und habe die v1.2.65 über die Fronttasten installiert und dann wieder wie gewohnt E2.
Dies brachte leider kein Erfolgserlebnis, E2 bootet immernoch nicht. Also ran an die Bootargs.
Beim auslesen mit printenv fiel mir kein Fehler auf, bis auf, daß es bei boot_system=enigma2 stehen bleibt.
Bevor ich mich an setenv waage, würde ich gern euere Meinung dazu hören/lesen.
Vlt. sehe ich den Wald vor lauter Bäume nicht?
Quellcode
- Board: STx7105-PDK [32-bit mode]
- U-Boot 1.3.1 (Jun 19 2012 - 17:10:44) - stm23_0051 - YW_1.1.005 overclock
- DRAM: 256 MiB
- Panel: VFD
- NAND: Bad block table found at page 262080, version 0x01
- Bad block table found at page 262016, version 0x01
- 512 MiB
- SPI: info: found S25FL016K (2MiB) device (page=256,erase=65536)
- warning: SPI device may be write-protected (status=0x9c)
- In: serial
- Out: serial
- Err: serial
- Ident ic exist
- Ident ic get stb id
- IdentID : 0c 00 07 00 00 1b eb
- Hit ESC to stop autoboot: 3
- Force command mode:Select boot (current boot system : spark):
- 1. spark(up key)
- 2. enigma2(down key)
- 3. RS232 Upgrade u-boot(left key)
- 4. Force into factory mode(right key)
- Input Select:
- set bootargs to bootargs_enigma2
- ..
- SUCC 0
- Loading from NAND 512MiB 3,3V 8-bit, offset 0x18000000
- ** Bad Magic Number 0xffffffff **
- ## Booting image at 80000000 ...
- Bad Magic Number
- PDK7105> printenv
- bootdelay=3
- baudrate=115200
- yw_version=YW_1.1.005
- board=pdk7105
- monitor_base=0
- monitor_len=0x00100000
- load_addr=0x80000000
- HOSTNAME=LINUX7167
- ethaddr=00:80:E1:12:06:38
- ipaddr=192.168.40.63
- netmask=255.255.255.0
- gatewayip=192.168.40.1
- serverip=192.168.40.19
- bootcmd_spark=nboot.i 0x80000000 0 0x00100000 ;bootm 0x80000000
- bootcmd_enigma2=nboot.i 0x80000000 0 0x18000000 ;bootm 0x80000000
- kernel_base_spark= 0x00100000
- kernel_base_enigma2= 0x18000000
- kernel_len_spark= 0x00a00000
- kernel_len_enigma2= 0x00800000
- erase_env=mw.b $load_addr 0 0x20000;eeprom write $load_addr 0x000a0000 0x20000
- loadu_uboot=fatload usb 0 $load_addr u-boot.bin
- loadu_kernel_spark=fatload usb 0 $load_addr mImage
- loadu_kernel_enigma2=fatload usb 0 $load_addr uImage
- loadu_userfs_spark=fatload usb 0 $load_addr userfsub.img
- loadu_userfs_enigma2=fatload usb 0 $load_addr e2jffs2.img
- tftp_uboot=tftp $load_addr u-boot.bin
- tftp_kernel=tftp $load_addr $tftp_kernel_name
- tftp_kernel_spark=tftp $load_addr mImage
- tftp_kernel_enigma2=tftp $load_addr uImage
- tftp_userfs=tftp $load_addr $tftp_userfs_name
- tftp_userfs_spark=tftp $load_addr userfsub.img
- tftp_userfs_enigma2=tftp $load_addr e2jffs2.img
- erase_kernel=nand erase 0x00100000 0x00a00000
- erase_userfs=nand erase 0x01400000 0x16c00000
- erase_kernel_enigma2=nand erase 0x18000000 0x00800000
- erase_userfs_enigma2=nand erase 0x18800000 0x07700000
- write_kernel=nand write.i 0x80000000 0x00100000 $filesize
- write_userfs=nand write.yaffs2 0x80000000 0x01400000 $filesize
- write_kernel_enigma2=nand write.i 0x80000000 0x18000000 $filesize
- write_userfs_enigma2=nand write.jffs2 0x80000000 0x18800000 $filesize
- update=eeprom write $load_addr $monitor_base $monitor_len
- update_kernel=nand erase 0x00100000 0x00a00000 ;nand write.i 0x80000000 0x00100000 $filesize
- update_userfs=nand erase 0x01400000 0x16c00000 ;nand write.yaffs2 0x80000000 0x01400000 $filesize
- update_kernel_enigma2=nand erase 0x18000000 0x00800000 ;nand write.i 0x80000000 0x18000000 $filesize
- update_userfs_enigma2=nand erase 0x18800000 0x07700000 ;nand write.jffs2 0x80000000 0x18800000 $filesize
- tftp_kernel_name_spark=mImage
- tftp_kernel_name_enigma2=uImage
- tftp_userfs_name_spark=userfsub.img
- tftp_userfs_name_enigma2=e2jffs2.img
- kernel_name_spark=spark/mImage
- kernel_name_enigma2=enigma2/uImage
- userfs_name_spark=spark/userfsub.img
- userfs_name_enigma2=enigma2/e2jffs2.img
- userfs_base_spark= 0x01400000
- userfs_base_enigma2= 0x18800000
- userfs_len_spark= 0x16c00000
- userfs_len_enigma2= 0x07700000
- uboot_name=u-boot.bin
- ubootnfspath=192.168.40.19:/opt/target
- kernelnfspath=192.168.40.19:/opt/target
- rootfsnfspath=192.168.40.19:/opt/target
- bootfromnfs=console=ttyAS0,115200 rw root=/dev/nfs nfsroot=192.168.40.19:/opt/target,nfsvers=2,rsize=4096,wsize=8192,tcp nwhwconf=device:eth0,hwaddr:00:80:E1:12:40:61 ip=192.168.40.61:192.168.40.19:192.168.3.1:255.255.0.0:LINUX7167:eth0:off stmmaceth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=7000
- bootargs_flash=console=ttyAS1,115200 rw ramdisk_size=6144 root=/dev/ram0 init=/linuxrc nwhwconf=device:eth0,hwaddr:00:80:E1:12:40:69 ip=192.168.0.69:192.168.3.119:192.168.3.1:255.255.0.0:Spark:eth0:off stmmaceth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=7000
- bootargs_spark=console=ttyAS1,115200 rw ramdisk_size=6144 root=/dev/ram0 init=/linuxrc nwhwconf=device:eth0,hwaddr:00:80:E1:12:40:69 ip=192.168.0.69:192.168.3.119:192.168.3.1:255.255.0.0:Spark:eth0:off stmmaceth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=7000
- bootargs_enigma2=console=ttyAS1,115200 rw root=/dev/mtdblock6 rootfstype=jffs2 init=/bin/devinit coprocessor_mem=4m@0x40000000,4m@0x40400000 printk=1 nwhwconf=device:eth0,hwaddr:00:80:E1:12:40:61 ip=172.100.100.249:172.100.100.174:172.100.100.174:255.255.0.0:Enigma2:eth0:off stmmaceth=msglvl:0,phyaddr:2,watchdog:5000 bigphysarea=6000
- ywenv_version=1
- loadu_userfs=fatload usb 0 $load_addr userfsub.img
- loadu_kernel=fatload usb 0 $load_addr mImage
- filesize=5D3D500
- fuseburned=true
- stdin=serial
- stdout=serial
- stderr=serial
- bootargs=console=ttyAS1,115200 rw root=/dev/mtdblock6 rootfstype=jffs2 init=/bin/devinit coprocessor_mem=4m@0x40000000,4m@0x40400000 printk=1 nwhwconf=device:eth0,hwaddr:00:80:E1:12:40:61 ip=172.100.100.249:172.100.100.174:172.100.100.174:255.255.0.0:Enigma2:eth0:off stmmaceth=msglvl:0,phyaddr:2,watchdog:5000 bigphysarea=6000
- kernel_base= 0x18000000
- kernel_len= 0x00800000
- kernel_name=enigma2/uImage
- userfs_name=enigma2/e2jffs2.img
- tftp_kernel_name=uImage
- tftp_userfs_name=e2jffs2.img
- userfs_len= 0x07700000
- userfs_base= 0x18800000
- bootcmd=nboot.i 0x80000000 0 0x18000000 ;bootm 0x80000000
- boot_system=enigma2
- Environment size: 4611/131068 bytes
- PDK7105>