Halo,
I saw there is a potential ftdi_sio.ko module comment in /etc/softcam.OSCam of the last image, i have tried unsuccesfully to activate a smargo reader 1.4 to add a third reader to my hdbox but have encoutered several problems, i didn't found how to identify the usb bus:address needed in oscam.server, Is there a way to install the "lsusb" linux command or equivalent ?
#!/bin/sh
case "$1" in
start)
mknod /dev/sci0 c 253 0
mknod /dev/sci1 c 253 1
insmod /var/lib/sci.ko
mknod /dev/ttyUSB0 c 188 0
chmod 666 /dev/ttyUSB0
insmod /var/lib/usbserial.ko
#insmod /var/lib/pl2303.ko
insmod /var/lib/ftdi_sio.ko
I have tried with a theorical address may be a good one but had some rc4 error messages...
Can you tell me if i can already use smargo or if a serial phoenix is better ?
Thank's for your brillant img
Jean
I saw there is a potential ftdi_sio.ko module comment in /etc/softcam.OSCam of the last image, i have tried unsuccesfully to activate a smargo reader 1.4 to add a third reader to my hdbox but have encoutered several problems, i didn't found how to identify the usb bus:address needed in oscam.server, Is there a way to install the "lsusb" linux command or equivalent ?
#!/bin/sh
case "$1" in
start)
mknod /dev/sci0 c 253 0
mknod /dev/sci1 c 253 1
insmod /var/lib/sci.ko
mknod /dev/ttyUSB0 c 188 0
chmod 666 /dev/ttyUSB0
insmod /var/lib/usbserial.ko
#insmod /var/lib/pl2303.ko
insmod /var/lib/ftdi_sio.ko
I have tried with a theorical address may be a good one but had some rc4 error messages...
Can you tell me if i can already use smargo or if a serial phoenix is better ?
Thank's for your brillant img
Jean