in oscam server to cccam line only this i have to change: # this line acts as a cccam 2.0.11 client ( recommended ) # [reader] #label = cccam_server #enable = 1 #protocol = cccam #device = myserver.homelinux.com,12000 #account = username #password = password #cccversion = 2.0.11 #cccmaxhops = 3 # dont use higher than 3 !!! #group = 2 #inactivitytimeout = 1 #reconnecttimeout = 30 only this will be in oscam server?

nice you say but how i set up oscam.where i put my line and what esle must do?

the freezes that i have maybe is from server?

Zitat von Googgi: „Have you edited mg_cfg for newcamd-protocol? >>> G: { 01 } camconfig.plugin tested to get a compatible N-Line? Please also update to Firmware 1.2.09“ its ok now play with g:{ 1 }.is better firmware that?

Zitat von Googgi: „c-lines in cccamd.list n-lines in newcamd.list and edit mg_cfg for your used protocol.“ i put line to newcamd.list and AFTER that i run in plug menu mgcamd.sh4 what i do wrong?

Zitat von Googgi: „Please use camconfig.plugin to edit your line. after that you have to start mgcamd.plugin in Plugin-Menu.“ I use flashxp to change my line.i put my line in cccam.cfg?or in newcamd.list? my line started CWS= IP USER PASS PORT 010203..... IN plug in menu i run mgcamd.sh4 or mgcamd.sh4.plugin?now i have firmware 1.1.42

edit by googgi: needless quote deleted my line in which file i put it?and which plug in i started?

hi i want to ask i have put mgcamd plug in,in edision pinglux with firmware 1.2.09 ,after that i put line in the newcamd.list but no picture.what i do wrong?

firmware - Version 1.2.09 support 3G-USB-Modem ? for argus pinglux?