[quote = 'neo3103', 'https: //www.hdfreaks.cc/index.php/Thread/31762-White-VFD/? postID = 260744 # post260744'] [quote = 'Koivo', 'https: // hdfreaks.cc/index.php/Thread/3…?postID=260742#post260742'] Take off the complete power for some minutes. [/ quote] This, and remove all cable for 5-10 minutes . Then plug in and turn on. [/ Quote] Hey, how can you manage all your Gblues without accidental cross-commands by same (I think) remote controls?

Hello The VFD has turned white for some days, details (time, progress bar etc.) can hardly be seen. Is there some setting to fix, or should I send for repair? Thanks

OK procedure seems to work. Many thanks

Unfortunately bad news: another log while software updating of build 67. Will try with version 6.4. Log attached. Be good

Done. Will come back if bad news. Thanks

Hello I found too many popups "your receiver encountered a software problem". This applies to other receivers too, so that I'm flashing other images. Attached many logs, the last one while playing a file.

No way. For now I will use Open ATV. Thanks anyway

I noticed that last release was 25.08.2020, which was already installed and showed the issue. I don't think it will be solved by re-flashing the same image, however I will do and revert.

I'm going to reload HDF and send feedback asap Thanks!

Thanks, but with Open ATV no need to tune to full HD channel

Hello No signal at HDMI IN, under both versions 6.4/6.5. It works perfect instead under Open ATV. Comments/suggestions appreciated. Thanks

Yes, this looked strange to me too. However the issue seems vanished after restart by rear switch

Quad 4k as per this section, image 6.5 build 53 It happened after a couple of days in deepstandby, vertical light on front panel being orange, while normally red/blue/off.

Hi Unfortunately, again the box fails to restart from deepstandby . Any suggestion? Thanks

Hi I gave up with version 6.5 due to unsolved problems, and went back to version 6.4. After some days without problems, a recurring crash occurs on restart from deep standby (crash>restart>crash endlessly). Same issue restarting by rear switch. Logs attached. Thanks

Hallo The spinner often starts running after a few minutes broadcasting or files playback. Restart by rear switch is needed. The issue with all daily updates of image 6.5, while no such problem with 6.4 up to now. Comments/suggestion appreciated.

Thanks so much

Hi Popup reporting sw problems appears under both images 6.5/6.4. Just button pressing sometimes causes problem. Last logs attached. Thanks

Thanks, but no channel appears under your parameters

Lan cable was connected besides internal wifi, so: 1. I disconnected LAN cable 2. Restarted 3. Opened Putty telnet option 4. Wrote password (even not legible!) After giving OK, finally next operations could be possible! Thanks