Hi everyone, Merry Christmas to you all!
I wanted to let you know that after flashing the new 7.0 image (127) for the Xtrend 10000
there is a problem where suddenly the rebooting process stops at just before the half way
and will not progress further. When i switch off from the switch at the back and switch on
again the same thing happens. The only thing we can do is reflash an old HDF backup from usb
then flash another fresh image but the same thing happens again after a while. All of a sudden
we have SR of 0% SR and the tuner is unable to tune into any channel and not able to scan any channels
then after rebooting the problem i have described starts. I have now flashed an older version of 7.0 from
2 versions previously in the hope this doesn't happen again.
Any advice would be appreciated.
I wanted to let you know that after flashing the new 7.0 image (127) for the Xtrend 10000
there is a problem where suddenly the rebooting process stops at just before the half way
and will not progress further. When i switch off from the switch at the back and switch on
again the same thing happens. The only thing we can do is reflash an old HDF backup from usb
then flash another fresh image but the same thing happens again after a while. All of a sudden
we have SR of 0% SR and the tuner is unable to tune into any channel and not able to scan any channels
then after rebooting the problem i have described starts. I have now flashed an older version of 7.0 from
2 versions previously in the hope this doesn't happen again.
Any advice would be appreciated.