STB : Gigablue UHD UE 4k (2 DVB-S2X tuners)
LNB : Inverto IDLU-32UL40-UNBOO-OPP (Unicable II)
Image : HDFreaks 6.5
I'm Using only one satellite (28.2) with no switches, only a single cable from LNB to tuner A input on STB.
Tuner A is working normally, and I can view channels.
When I try and configure tuner B - H, according to the WIKI here: Unicable wiki , I cannot "save" the settings (green button), the message "your STB has encountered a problem and needs to restart"
I think the Wiki is a little outdated? What should I choose for "TUNER ALGORITHM" ??
The screenshots of my tuner config screens are attached.
The Unicable LNB is working fine on OpenVIX, so I know it's not a hardware problem. I can't get the Unicable configured on OpenPLI 8 either.
Thanks for any help.-182021-119.jpg-182021-1119.jpg
LNB : Inverto IDLU-32UL40-UNBOO-OPP (Unicable II)
Image : HDFreaks 6.5
I'm Using only one satellite (28.2) with no switches, only a single cable from LNB to tuner A input on STB.
Tuner A is working normally, and I can view channels.
When I try and configure tuner B - H, according to the WIKI here: Unicable wiki , I cannot "save" the settings (green button), the message "your STB has encountered a problem and needs to restart"
I think the Wiki is a little outdated? What should I choose for "TUNER ALGORITHM" ??
The screenshots of my tuner config screens are attached.
The Unicable LNB is working fine on OpenVIX, so I know it's not a hardware problem. I can't get the Unicable configured on OpenPLI 8 either.
Thanks for any help.-182021-119.jpg-182021-1119.jpg